Bit0 Bit1 Bit2 Bit3 Led0 FALSE => IO Channel Value, TRUE => User Value Led1 FALSE => IO Channel Value, TRUE => User Value Led2 FALSE => IO Channel Value, TRUE => User Value Led3 FALSE => IO Channel Value, TRUE => User Value Led4 FALSE => IO Channel Value, TRUE => User Value Led5 FALSE => IO Channel Value, TRUE => User Value Led6 FALSE => IO Channel Value, TRUE => User Value Led7 FALSE => IO Channel Value, TRUE => User Value FALSE Status LED CTRL Status LED indication => TRUE: User controlled, FALSE: System Status Indication FALSE Status LED Value Only applicable if Status LED CTRL is enabled => TRUE: LED on, FALSE: LED off FALSE 1-Wire power shutdown Useful for bus reset in case of freeze => TRUE: 1-Wire bus power down, FALSE: normal operation FALSE [RESERVED] RESERVED: Always FALSE FALSE Counter 1 Reset TRUE: COUNTER1 Value reset request, FALSE: normal operation FALSE Counter 2 Reset TRUE: COUNTER2 Value reset request, FALSE: normal operation FALSE [FUTURE] FUTURE: Sign of Life 0/1 - should be incremented with each data transfer as 2bit number low/high bit, used by firmware as health check of SPI Master FALSE [FUTURE] FUTURE: Sign of Life 0/1 - should be incremented with each data transfer as 2bit number low/high bit, used by firmware as health check of SPI Master FALSE AIN1 Shunt AIN1 current loop shunt resistor enable (TRUE / FALSE) FALSE AIN2 Shunt AIN2 current loop shunt resistor enable (TRUE / FALSE) FALSE RS-485 Termination resistor RS-485 termination resistor enable (TRUE / FALSE) Digital In Analog In1 Analog In2 Digital Out Analog Out1 Analog Out2 16#1 Control Byte Control Byte HW Config HW Config Byte device.png device.ico Interface.ico 501 0004 0005 2.0.1.4 Monarco HAT An I/O driver for Monarco HAT written by Aliazzz Open Source - device.png device.ico SPI devices Input Channels Input Channels Output Channels Output Channels Configuration Configuration COM Interface.ico 1