Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am very new to this and am having a problem getting any code to correctly link with C3 software.
I am following a guide but when ever I try to link the software I am told that "no compiled IEC61131-3 binary file found! Please compile project with Codesys DIE" (i am assuming that is meant to be IDE), Image attached.
The only thing that is different from the tutorial I am watching is when they build there get a compiler pop up (image attached), while mine just checks for errors and says its done.
Any help on this topic would be greatly appreciated.
Hello all,
I am very new to this and am having a problem getting any code to correctly link with C3 software.
I am following a guide but when ever I try to link the software I am told that "no compiled IEC61131-3 binary file found! Please compile project with Codesys DIE" (i am assuming that is meant to be IDE), Image attached.
The only thing that is different from the tutorial I am watching is when they build there get a compiler pop up (image attached), while mine just checks for errors and says its done.
Any help on this topic would be greatly appreciated.
Thanks
Jack