Program freezes after I click 'Run'

2020-02-27T20:18:43.942000Z

Thanks for your help! It apparently was an infinite loop.

Program freezes after I click 'Run'

2020-02-27T20:18:42.567000Z

Originally created by: scott_cunningham

This typically happens when you write to a memory location you shouldn't and the PLC crashes.

Many possibilities:

Defining an array[1..9] and then forgetting vars init to 0:

VAR
  J:INT;
  aBad : ARRAY[1..9] OF INT;
END_VAR
aBad[j] := 27;

This will compile but crash or act weird when run..

Using a pointer that points to a wrong location.

Etc

Program freezes after I click 'Run'

2020-02-27T20:18:41.227000Z

first make a simple blinker program,check for correct working and communication.
be sure the program is not activating watchdog, and does not change the internet settings.
if still problems zip program and put it here.

Program freezes after I click 'Run'

2020-02-27T20:18:37.493000Z

I am running a Codesys 2.3 program on a WAGO PLC ethernet controller. After I upload the program and click 'Run', the communication with the controller freezes (as it appears). I can't communicate with the controller until I physicall reset the device and reload all the network settings.

Does someone have advice for this situation?

Thanks!

Recent posts to Program freezes after I click 'Run'

Program freezes after I click 'Run'

Program freezes after I click 'Run'

Program freezes after I click 'Run'

Program freezes after I click 'Run'