https://forge.codesys.com/forge/talk/CODESYS-V2/thread/3372a0f1e1/2020-02-27T22:57:30.140000ZRecent posts to Can't connect to WAGO IPC C10E via CoDeSys2020-02-27T22:57:30.140000Z2020-02-27T22:57:30.140000Zhki75https://forge.codesys.com/u/hki75/https://forge.codesys.coma6abaab407a9c87bba55ab8db1f64eda05d9b191

<div class="markdown_content"><p>Wago devices need the k-Bus termination module. <br/> Without it codesys comm do not work. <br/> The minimum configuration to have online communication via codesys is: CPU + 1module (DI,DO,AI,AO, Serial,...) + k-bus termination</p> <p>Regards</p></div>

2020-02-27T22:57:28.520000Z2020-02-27T22:57:28.520000Zshooterhttps://forge.codesys.com/u/shooter/https://forge.codesys.coma80e3e3e7cdf7eb40ff3ee614812d36ca126cd60

<div class="markdown_content"><p>are ethernet settings in controller oke. start ethernet settings separate program from wago, free available on website.<br/> on 750 series there is a small hatchcover and a switch below. see manual for position of this switch.</p></div>

2020-02-27T22:57:24.035000Z2020-02-27T22:57:24.035000ZYougihttps://forge.codesys.com/u/yougi/https://forge.codesys.com9cd118d249fd0204808bdf42e703414fc24efb8b

<div class="markdown_content"><p>Hello,<br/> I'm trying to login with WAGO IPC C10E from the CoDeSys IDE to download test project.<br/> Always pop up message "Communication error (#0)". <br/> Project is some dummy - PLC_PRG with few rows of code and simple visu with one button - for test only.<br/> Ethernet cable connected to X8, 192.168.1.20 ( default setting ). Ping ok, ftp ok, telnet ok. <br/> Communication parameters IP adr 192.168.1.20 port 1200. <br/> Computer in same network with IP 192.168.1.99. Two devices only in network. <br/> On K-bus only one DI module 750-430. <br/> Any ideas to improve situation?</p></div>