Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi, I realise it is a stretch to put this question on this forum but I'm working in CoDeSys 2.3.9.6 so I'll ask it here anyway.
I have been trying to receive Engine diagnostics from a CAT C18 engine by a CR0505 unit. I can get the diagnostics code with the highest priority but not any of the others. The documentation says that it should be able to store 10 codes, any ideas how to achieve this?
Again appoligies for putting this in this forum but this is the only forum I'm actually a member of and trust.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I can help you. What PGN or Diagnostic are specifically trying to read? I control engines with IFM PLC's although I am not an expert I think we can figure it out. Have you looked at the new IFM engine J1939 specific libraries? Not sure if there is a CAT one or if the diagnostic you are looking for is written. I have used Detroit Diesel, and Cummins.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
spfeif: thanks for your answers, I also have the same doubts but in my house it is to control and visualize the parameters of a DEUTZ diesel engine, please if you could support me with your time
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: Carmichael_keith
Hi, I realise it is a stretch to put this question on this forum but I'm working in CoDeSys 2.3.9.6 so I'll ask it here anyway.
I have been trying to receive Engine diagnostics from a CAT C18 engine by a CR0505 unit. I can get the diagnostics code with the highest priority but not any of the others. The documentation says that it should be able to store 10 codes, any ideas how to achieve this?
Again appoligies for putting this in this forum but this is the only forum I'm actually a member of and trust.
I can help you. What PGN or Diagnostic are specifically trying to read? I control engines with IFM PLC's although I am not an expert I think we can figure it out. Have you looked at the new IFM engine J1939 specific libraries? Not sure if there is a CAT one or if the diagnostic you are looking for is written. I have used Detroit Diesel, and Cummins.
spfeif: thanks for your answers, I also have the same doubts but in my house it is to control and visualize the parameters of a DEUTZ diesel engine, please if you could support me with your time