Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to use a digital input to set the .CU input of a CTU instance, in order to count the number of pulses of a pulsed signal. I can see the digital input fluctuating and setting .CU high and low, although the .CD count just shows zero. It seems as though the .M rising edge detection variable is always false. .RESET is set to false - I made sure that the count was not being reset elsewhere in the code. Does anyone have an idea why this could be happening?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm trying to use a digital input to set the .CU input of a CTU instance, in order to count the number of pulses of a pulsed signal. I can see the digital input fluctuating and setting .CU high and low, although the .CD count just shows zero. It seems as though the .M rising edge detection variable is always false. .RESET is set to false - I made sure that the count was not being reset elsewhere in the code. Does anyone have an idea why this could be happening?
from your description, I suspect you have not called the CTU_Instance() anywhere in your code
That makes sense!