Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

CoDeSys Exception EIP Adapter

  • mani-i4point0

    mani-i4point0 - 2022-09-13

    I am newbie here, In my Project I am using CoDeSys Runtime whihch running in raspberry pi.
    One of the Ethernet Post has been configured as EIP Adapter and other one as a EIP Scanner.
    The One which has been configured as a EIP Adapter getting into exception state at a regular interval.
    Unable to identify the Root-Cause of this Issue.
    Any help in fixing this highly appreciated.

    Attaching the Exception image for your ready reference.

    Best regards,

  • eschwellinger

    eschwellinger - 2022-09-14

    check if you are up to date with your EIP version. If a newer version is available install it and then update the project by richtclick on the EIP scanner - update device
    (current version is


    Last edit: eschwellinger 2022-09-14
    • mani-i4point0

      mani-i4point0 - 2022-09-14

      thanks for your input, I have updated and kept the system under observation. Wil update you if i face any challenges.
      Thanks Again.

  • mani-i4point0

    mani-i4point0 - 2022-10-06

    Hi Everyone,
    I am still, getting the Exception even after disabling the watchdog.
    In my Project, I have configured the EIP hardware tasks in Cyclic mode,
    Is this could be a reason for these Exception?
    Is it better to configure the hardware in Freewheeling type?
    Your valuable input highly appreciable.

    Best regards,


Log in to post a comment.