Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
1 - Is it possible to manually connect a line between 2 FB? If I drag a FB on the output of another FB, it will automatically connect it to the first input. But if I want it connected to the second input, I cannot find a way to move the yellow line.
2 - How can I connect 2 FB on 2 different network (rung)? I know I can explicitly write the name and of the FB in the input of the other FB, but if I have nothing connected to the output of the first FB, it will not build.
1 - Is it possible to manually connect a line between 2 FB? If I drag an FB on the output of another FB, it will automatically connect it to the first input. But if I want it connected to the second input, I cannot find a way to move the yellow line.
No, this is not possible. You can instead split your Network 1 into two, like in the following image:
2 - How can I connect 2 FB on 2 different network (rung)? I know I can explicitly write the name and of the FB in the input of the other FB, but if I have nothing connected to the output of the first FB, it will not build.
You can connect it as shown in the image above. There are no compile errors, if the output of FB_OR_1 is not connected to an output.
Hello,
2 questions:
1 - Is it possible to manually connect a line between 2 FB? If I drag a FB on the output of another FB, it will automatically connect it to the first input. But if I want it connected to the second input, I cannot find a way to move the yellow line.
2 - How can I connect 2 FB on 2 different network (rung)? I know I can explicitly write the name and of the FB in the input of the other FB, but if I have nothing connected to the output of the first FB, it will not build.
Am I the only one using the Safety Editor?
No one? Anyone?
give us some time ..
Ok, thanks
Hi,
1 - Is it possible to manually connect a line between 2 FB? If I drag an FB on the output of another FB, it will automatically connect it to the first input. But if I want it connected to the second input, I cannot find a way to move the yellow line.
No, this is not possible. You can instead split your Network 1 into two, like in the following image:
2 - How can I connect 2 FB on 2 different network (rung)? I know I can explicitly write the name and of the FB in the input of the other FB, but if I have nothing connected to the output of the first FB, it will not build.
You can connect it as shown in the image above. There are no compile errors, if the output of FB_OR_1 is not connected to an output.
I am sure the last time I tried it was not working, but I tried it again today and it works. I must have done something wrong the last time.
Thank you.