Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
So if a system is completed and in the field, and I need to replace an ECU but have a different Node Address, Can I program it in the future so I could select an address via visualization? My situation would be a Joystick ordered with a different Address. From what I have seen I need to assign the address during development and remote ECU addresses can't be changed programmatically. Anyone know if this is possible
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
So if a system is completed and in the field, and I need to replace an ECU but have a different Node Address, Can I program it in the future so I could select an address via visualization? My situation would be a Joystick ordered with a different Address. From what I have seen I need to assign the address during development and remote ECU addresses can't be changed programmatically. Anyone know if this is possible
Thanks