Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Codesys V3.5.18 and KNX

  • Sandro - 2022-06-17

    Hi all,
    I am using Codesys 3.5 SP18 with:
    - CODESYS Control for Raspberry Pi SL (license in USB KEY)
    - CODESYS KNX SL (license in USB KEY
    I have configured both Codesys and ETS but it is not communicating.
    On the KNX side I am using the "IP Interface SCN-IP000.03" (MDT) and I think this is the problem (in other topic Edwin recommend an IP ROUTER).
    So I should replace the interface with "IP Router SCN-IP100.03" (MDT).
    Do you think this could be the solution?
    In the windows KNX I/O Mapping the variable Program LED Status and Program Button are BOOL but the variable are %IB0 and %QB0. Shouldn't it be% IX0.0 and & QX0.0?
    I am attaching some screenshots.
    Thank you

  • Sandro - 2022-07-04

    Can anyone answer me?
    Thank you

  • Sandro - 2022-12-25

    Hi everyone,
    since I haven't received information from anyone, if it can be useful to someone else, after some tests I discovered that the system can only work using an IP-ROUTER (I used an "IP Router SCN-IP100.03" from MDT).


Log in to post a comment.