Error handling while reading Modbus TCP

2020-02-27T13:56:49.205000Z

Each modbus slave device has a property "byModbusError".
In your case you can use e.g. the following code:

Mb1State := Modbus_TCP_Slave.byModbusError;

Mb1State is then of the following type:

VAR
   Mb1State: IoDrvModbusTCP.MB_ErrorCodes;
END_VAR

In the library "IoDrvModbusTCP" you can find this ENUM (in the Structs folder) to see the details.

Error handling while reading Modbus TCP

2020-02-27T13:56:48.463000Z

If you have control over the slaves you could toggle a bit and increase a counter on the slave side and read that back, make sure it increases. But if there is a way to access the on board diagnostics from Codesys that would be nice.

Sent from my SM-G935F using Tapatalk

Error handling while reading Modbus TCP

2020-02-27T13:56:48.235000Z

Hi..

In my project I want to read registers from a modbus tcp slave device. In normal conditions everything is ok but I must handle an error bit while an reading or socket error at communication.
For example when turn off the power of slave device, a communication error occurs. So how can understand the error of modbus tcp.

Thanks already..

Recent posts to Error handling while reading Modbus TCP

Error handling while reading Modbus TCP

Error handling while reading Modbus TCP

Error handling while reading Modbus TCP