Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I can not add a MODBUS TCP Master to my 3.5.16.10 project, browsing the device repository I can see the version of the driver is listed as 3.5.16.0, does this mean the MODBUS TCP Master device can only be added in a 3.5.16.0 project?
From the codesys store description, the MODBUS TCP Master is listed in the features, but it does not seem present in a clean installation of the IDE.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I was just thrown off by the possibility to add a Modbus RTU and not a TCP, but that is explained by the Ethernet interface host being a difference between them.
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi
I can not add a MODBUS TCP Master to my 3.5.16.10 project, browsing the device repository I can see the version of the driver is listed as 3.5.16.0, does this mean the MODBUS TCP Master device can only be added in a 3.5.16.0 project?
From the codesys store description, the MODBUS TCP Master is listed in the features, but it does not seem present in a clean installation of the IDE.
Sure ..first add Ethernet connector...then modbus master...
I should have googled that before asking :)
I was just thrown off by the possibility to add a Modbus RTU and not a TCP, but that is explained by the Ethernet interface host being a difference between them.
Thank you.