Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am looking for a solution to the problem of losing connection with a slave. It is H100 inverter, when the inverter starts up, everything is fine until the connection is lost. Even though I have auto restart enabled, I cannot get the connection until the inverter is turned off and on again. Over and over again.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I am looking for a solution to the problem of losing connection with a slave. It is H100 inverter, when the inverter starts up, everything is fine until the connection is lost. Even though I have auto restart enabled, I cannot get the connection until the inverter is turned off and on again. Over and over again.