Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

2023-02-11T09:53:16.812000Z

Hi,
for me it works that way on br1 and with separated interfaces.
If you let CODESYS change the IP Adress you need additional:

[SysSocket]
Adapter.0.Name="br1"
Adapter.0.EnableSetIpAndMask=1

added in /etc/CODESYSControl_Usr.cfg ( then you could enable the setting 'Adjust operating system setting'

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

2023-02-10T14:54:59.499000Z

Do you mean like this?
I'm still getting the same error..

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

2023-02-10T14:49:18.580000Z

seperate the ethernet interfaces on PFC200 use the br1 on the controller

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

2023-02-10T13:58:45.805000Z

I'm working on a project where I want to have the following:

WAGO 750-8212 as controller
WAGO 750-340 as device
Raspberry Pi 4 as device

All devices are on the same local network and I've set static IP-s for the devices. However in Codesys V3.5 SP18 Patch 4, I can't seem to get the Profinet controller to activate when put into run:

I have the following error message(s):

WinPcap is already installed (5.1.72.1206) so this thread is to no use. https://forge.codesys.com/forge/talk/Engineering/thread/4dee464d00/

Is there anything else I can do to make this work?

Recent posts to Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"

Profinet not working on WAGO 750-8212 "Opening Ethernet Adapter Failed"