CODESYS Forge - CODESYS Forge / Talk / Engineering 🇬🇧: Both edge's trigger

Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Both edge's trigger

Forum: Engineering 🇬🇧

Creator: dawidr

Created: 2022-12-19

Updated: 2022-12-19

dawidr - 2022-12-19

Is there build-in function block which acts like R_TRIG and F_TRIG at the same time?
So basically detects both rising or falling edge?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

ph0010421 - 2022-12-19

Just put a R_TRIG and F_TRIG in a new FB

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

dawidr - 2022-12-19

Well, that is what I did but I wonder if there is something build-in.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

i-campbell - 2022-12-19

OSCAT BASIC B_TRIG does that.

👍
1

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.