Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am looking for some support after my project was corrupted during a PC crash.
I am using the sew eurodrive implementation of codesys and when I download to the controller it has not been creating a boot project at the same time. As a result the actual running application is not the same as the not project.
I am trying to recover this running application to minimise the rework required.
I tried the source upload but this is just the boot project which is old.
I did transfer all files from the controller to my PC so I do have a copy of the project.
I can't go online because the compile information is different without doing a full download.
Any ideas on how this can be recovered?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If sources weren't sent into your PLC, then you can only recover binaries, which is only useful as a backup. You can later use this backup to download on a fresh new PLC, but you can't edit or modify it with codesys.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
I am looking for some support after my project was corrupted during a PC crash.
I am using the sew eurodrive implementation of codesys and when I download to the controller it has not been creating a boot project at the same time. As a result the actual running application is not the same as the not project.
I am trying to recover this running application to minimise the rework required.
I tried the source upload but this is just the boot project which is old.
I did transfer all files from the controller to my PC so I do have a copy of the project.
I can't go online because the compile information is different without doing a full download.
Any ideas on how this can be recovered?
If sources weren't sent into your PLC, then you can only recover binaries, which is only useful as a backup. You can later use this backup to download on a fresh new PLC, but you can't edit or modify it with codesys.
Ok, Thats unfortunate. I will need to be more vigilant with saving and backing up in the future.
Thanks for the reply