Trying to install the CODESYS Control for PFC100 SL i get error messages. Anyone know what could be the problem/solution?
never seen, which firmware is this,what happens if you install it by login by ssh and:
ipkg install codesyscontrol_arm_pfc200_V3.5.13.x.ipk
I am using this package: codesyscontrol_arm_pfc100_V184.108.40.206.ipk
Using ssh I get the same error:
root@PFC100-416D28:~ ipkg install codesyscontrol_arm_pfc100_V220.127.116.11.ipk
ipkg: Couldnt kill old gunzip process aborting
If I log into the web interface of the PLC I get the 3S interface and not the wago Interface, It seems like it might be installed.
If I scan for PFC100 in the PFC100 phane in codesys I find it.
If I scan for the device in my project i don't find it.
If i try to start the Runtime using the start button in the PFC100 phane in codesys I get an error message..
See attached photos.
Installation is ok,
just add a Gateway with the IP of the PFC100. Switch to this new Gateway, then you will find the PFC100 by the scan.
Hello, thank you for the reply.
Adding a gateway with the IP of the PLC does not help. I get this error message.
could you Login by ssh (putty for example) and call
to chek if the runtime is running?
codesyscontrol.log is not found,
your screenshot say you are using Firmware(09) Version,
I would update to current Version ( request on Wago homepage for the new Firmware 11)
Boot with it from micro sd and update your Firmware by WBM in the browser...
Log in to post a comment.