Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

To implement G-code

conoscenza
2012-10-29
2012-10-31
  • conoscenza - 2012-10-29

    Hi to all!

    how to implement G-code into smc_interpolator/smc_geoinfo?

    I should to use G92 (assign a positioning without movement), but my project is based on smc_interpolator/smc_geoinfo and not on DIN66025.

    any suggestions?

    thank you in advanced

     
  • conoscenza - 2012-10-31

    Answer:

    If you want to implement some G-Functions in OUTQUEUE, which can be directly passed on to the Interpolator, you must run through Decoder, and you evaluate the variables into DecoderBuffer.

    Cheers!

     

Log in to post a comment.