Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Changing SlaveScaling Without CamOut

zeroptr
2022-07-13
2022-07-19
  • zeroptr - 2022-07-13

    Hi All,

    I'm using CodeSys Softmotion Ethercat on HCFA controller..

    Is it possible to change the  SlaveScaling without CamOut in a camming
    system or any useful ideas that not requre CamOut ?

    --
    Bu e-posta virüslere karşı Avast antivirüs yazılımı tarafından kontrol edilmiştir.
    https://www.avast.com/antivirus

     
  • imdatatas - 2022-07-14

    As stated by the General Rules section of PLCopen Motion Control Part 1 guidelines;

    With ‘Execute’ without ‘ContinuousUpdate’: The parameters are used with the rising edge of the ‘Execute’ input. To modify any parameter it is necessary to change the input parameter(s) and to trigger the ‘Execute’ input again.

    Same also can be applicable for MC_CamIn function block by retrigger it.

    Regards,
    imdatatas

     

    Last edit: imdatatas 2022-07-14
  • zeroptr - 2022-07-19

    Thanks A lot..

     

Log in to post a comment.