Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
I need some help to find the error in my axis control. I want to set a Schneider Lexium32 Axis Controller to power on and ready to drive by the function MC_Power (SM3_Basic). I inserted the function in my script and the visualization. The code is compiling without faults and the visu works fine. I can set the input parameters enable, bRegulatorOn and bDriveStart as true and the output Busy is set by the functionblock and there is no error message. But that's it. The outputs Status, Regulator and Drive are false. In the variable monitoring, I can see, that the input parameters are really set as true, but the parameters of the axis is fluctuating in those three variables and the state is varying between PowerOff and StandStill, so it never reaches the stable state StandStill. In configuration mode there are no problems to turn on the axis and move them, so I think I can be sure, that there is no hardware problem. The axis controller is also set to ready to drive. There is also nothing in the logs. I have no idea what's the fault.
In the attachment are some screenshots, which might be helpful.
Some additional informations about the system, I'm using: Codesys V3.5 SP16, Softmotion RTE V3 x64, EtherCAT communication
Thanks for reading, any information is appreciated. If you need any further details, let me know.
while cleaning my code for upload, I found my error. Thanks for asking. Sometimes cleaning helps. I was searching at the wrong parts.
The fault was an other task with motion functions, which was overwriting my functions block every cycle.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I need some help to find the error in my axis control. I want to set a Schneider Lexium32 Axis Controller to power on and ready to drive by the function MC_Power (SM3_Basic). I inserted the function in my script and the visualization. The code is compiling without faults and the visu works fine. I can set the input parameters enable, bRegulatorOn and bDriveStart as true and the output Busy is set by the functionblock and there is no error message. But that's it. The outputs Status, Regulator and Drive are false. In the variable monitoring, I can see, that the input parameters are really set as true, but the parameters of the axis is fluctuating in those three variables and the state is varying between PowerOff and StandStill, so it never reaches the stable state StandStill. In configuration mode there are no problems to turn on the axis and move them, so I think I can be sure, that there is no hardware problem. The axis controller is also set to ready to drive. There is also nothing in the logs. I have no idea what's the fault.
In the attachment are some screenshots, which might be helpful.
Some additional informations about the system, I'm using: Codesys V3.5 SP16, Softmotion RTE V3 x64, EtherCAT communication
Thanks for reading, any information is appreciated. If you need any further details, let me know.
I think you need to upload the project..
while cleaning my code for upload, I found my error. Thanks for asking. Sometimes cleaning helps. I was searching at the wrong parts.
The fault was an other task with motion functions, which was overwriting my functions block every cycle.