I get control of speed on a stepper motor but I can´t control the position.
How can I adjust EL2521 parameters to travel 1mm with 200 pulse to stepper motor?
Did you make it run 1mm as you mention? If yes please share
you need position feedback. I use EL5101 to read the
encoder on my stepoer
no this works that way without encoder...
without encoder I can´t control de position. Only control the speed.
It is posible by using Softmotion and related configuration from my screenshot. Just use then the MC_Move... fb's to control the position.
Log in to post a comment.