I was trying to set up BBB as a CANOpen device. I added one TPDO and one RPDO. But I couldn't seem to get the device running("Not Running" is shown in status). I have started CAN0 using the command "ip link set up can0 type can bitrate 250000". What am I missing?
Test.project [230.47 KiB]
I restarted the board and I got a bus failure. The diag message read "EMCY: Error Passive".
After that I brought CAN0 down and up, and made some minor changes to the program(just to make sure it recompiled), downloaded it again. And when the program started I got the same "Not Running" message on the device(the CANBUS says "Running") as before.
I hope this would help with the problem solving.
Log in to post a comment.