wquere - 2021-12-14

Hello!
I have an application that runs repeated cycles with a multi axis robot. It is supposed to run repetitively forever (until someone decide to stop it) but the application crashes after 507 cycle (about 9 hours).

I see that the last line of log gives an error:
**** ERROR: CmpVisuHandler: ExternId=<id>60645</id> removed due to timeout

My application is running on an emPC-X and i am using CodeSys V3.5 SP15 Patch 1 (64-bit).

Could someone help me to understand what do i need to change so that my application keeps running?
I attached the log after the crash, the config files as well a the PLC configuration window before and after, hope it helps.

Thank you in advance for the help!