Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
About your issue, I believe you are running in "Simulation Mode".
You should not run coUnit in Simulation Mode as the log output is not supported under simulation mode.
Please activate your local installed SoftPLC from the systray. After that, scan your PLC via the project and connect with it. Download and run ;-)
π
1
Last edit: aliazzz 2021-11-02
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi, I am unable to see the results from the coUnit in the Device Log. Do I have to do any further setting as mentioned above?
Any suggestions/pointers are welcome.
Attaching the screenshot.
Thanks!
Talk Topic about project #counit
About your issue, I believe you are running in "Simulation Mode".
You should not run coUnit in Simulation Mode as the log output is not supported under simulation mode.
Please activate your local installed SoftPLC from the systray. After that, scan your PLC via the project and connect with it. Download and run ;-)
Last edit: aliazzz 2021-11-02