Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello Everyone,
Regarding G code I have a question. I am drawing two seperate arc in CNC editor. From outside CNC editor, while running G code I want to reach next line GEO_INFO such as line starting point, starting tangent etc. With wich function block is it possible?
Normally I can see those data inside Editor. But want to reach to it while running G code, to make some positioning of additional axis…
thanks and regards
Hello Everyone,
Regarding G code I have a question. I am drawing two seperate arc in CNC editor. From outside CNC editor, while running G code I want to reach next line GEO_INFO such as line starting point, starting tangent etc. With wich function block is it possible?
Normally I can see those data inside Editor. But want to reach to it while running G code, to make some positioning of additional axis…
thanks and regards