https://forge.codesys.com/u/draygoon/activity/2023-03-06T05:01:57.365000ZRecent activity for draygoon2023-03-06T05:01:57.365000Z2023-03-06T05:01:57.365000Zdraygoonhttps://forge.codesys.com/u/draygoon/profile/https://forge.codesys.com/forge/talk/Engineering/thread/6a77876558/?limit=25#cb1c

The Problem isn´t solved yet, our project is cancelled (since Sep 22) caused of massive personal fluctuation. I personally found a solution using Phyton (in combination with RevPiModIO) while implementing the Pictory System by Kunbus for adress resolving. But as long the ModbusRTU-Hardware isn´t implemented by Kunbus in Codesys it probaply won´t work. Also, Kunbus is going to finish the support of any ModbusRTU caused by problemacity of hardware procurement.

2022-09-20T04:18:26.544000Z2022-09-20T04:18:26.544000Zdraygoonhttps://forge.codesys.com/u/draygoon/profile/https://forge.codesys.com/forge/talk/Engineering/thread/6a77876558/?limit=25#6853

The new released driver from codesys installed over the runtime also doesn't work. The flashing red triangle before each installed Modbus Slave is there because Kunbus (Maker of RevPI) didn't programmed status of the slaves (controlled over codesys) yet

2022-09-20T04:04:02.897000Z2022-09-20T04:04:02.897000Zdraygoonhttps://forge.codesys.com/u/draygoon/profile/https://forge.codesys.com/forge/talk/Engineering/thread/0a1dff91db/?limit=25#42e5

check out https://revpimodio.org/

2022-08-04T05:33:59.465000Z2022-08-04T05:33:59.465000Zdraygoonhttps://forge.codesys.com/u/draygoon/profile/https://forge.codesys.com/forge/talk/Engineering/thread/6a77876558/?limit=25#6ae6

It seems there isn't the modbus serial driver available for the RevPI. (pic below) How can I add Modbus to the Device Repository?

2022-08-04T05:32:42.268000Z2022-08-04T05:32:42.268000Zdraygoonhttps://forge.codesys.com/u/draygoon/profile/https://forge.codesys.com/forge/talk/Engineering/thread/6a77876558/?limit=25#6ae6

It seems there isn't the modbus driver available for the RevPI. (pic below) How can I add Modbus to the Device Repository?

2022-07-29T07:16:16.758000Z2022-07-29T07:16:16.758000Zdraygoonhttps://forge.codesys.com/u/draygoon/profile/https://forge.codesys.com/forge/talk/Engineering/thread/6a77876558/?limit=25#daed

Hi, I'm actually out of ideas how I can activate the serial port in Codesys (pic below). If I use the "Pictory"-System of Kunbus, I can ask regulary all registers from all attached units on the serial port of the Revolution PI. But when the Codesys Runtime is installed it overwrites the Kunbus Config. Modbus Master RTU isn´t installed on the RevPI. (pic below) Modbus TCP is working correctly when used. ttyAMA0 is set as Linux.Devicefile=/dev/ttyAMA0 in CODESYSControl_User.cfg, I also tried /dev/serial...