https://forge.codesys.com/u/magne/activity/2023-02-27T13:22:34.620000ZRecent activity for magne2023-02-27T13:22:34.620000Z2023-02-27T13:22:34.620000Zmagnehttps://forge.codesys.com/u/magne/profile/https://forge.codesys.com/forge/talk/Motion/thread/180a897ae1/?limit=25#ab85

Its working! Thank you very much eschwellinger, I had set the task cycle time to 50ms, i dont know exactly why but that seemed to be the problem, it is working after i set it back to 20ms. is it a hard limit to how long cycle time you can have for motion FBs to work? or is it possible to use a longer cycle time?

2023-02-27T12:22:24.523000Z2023-02-27T12:22:24.523000Zmagnehttps://forge.codesys.com/u/magne/profile/https://forge.codesys.com/forge/talk/Motion/thread/180a897ae1/?limit=25#69e8

Ok i found out why i didnt see anything in the watch window :P, i see that i have two additional SMC errors, but i dont know what they mean, could that be the problem?

2023-02-27T12:17:33.577000Z2023-02-27T12:17:33.577000Zmagnehttps://forge.codesys.com/u/magne/profile/https://forge.codesys.com/forge/talk/Motion/thread/180a897ae1/?limit=25#69e8

Ok i found out why i didnt see anything in the watch window :P, but i still dont know why the axis says its not ready for motion

2023-02-27T12:07:52.246000Z2023-02-27T12:07:52.246000Zmagnehttps://forge.codesys.com/u/magne/profile/https://forge.codesys.com/forge/talk/Motion/thread/180a897ae1/?limit=25#69e8

I know i am doing something wrong, i just dont know what. Nothing is appearing in Watch 1 window.

2023-02-27T08:44:32.623000Z2023-02-27T08:44:32.623000Zmagnehttps://forge.codesys.com/u/magne/profile/https://forge.codesys.com/forge/talk/Motion/thread/180a897ae1/?limit=25#4ef5

Ok, I have done some searching through Codesys help and i am not sure if i found the watch window you are talking about, I found in the View tab Watch 1-4 and "Watch all forces", is this correct? there are no errors appearing in these windows under simulation

2023-02-26T10:51:45.114000Z2023-02-26T10:51:45.114000Zmagnehttps://forge.codesys.com/u/magne/profile/https://forge.codesys.com/forge/talk/Motion/thread/180a897ae1/?limit=25#060f

Hello Everyone! I am a student and pretty new to Codesys and Motion control systems in general. I am having a problem in my Codesys project where i keep getting the SMC_ERROR 34 SMC_AXIS_NOT_READY_FOR_MOTION. What i find strange is that i am getting this error while the status output on my MC_POWER functionblock is true. I am using the WARP Device (CODESYS SoftMotionRTE V3 x64) and the SM_Drive_Virtual device. What am i doing wrong? any help would be greatly appreaciated!