Hi Sir Kevin. May I know how you came up with this solution. Im a bit confused but I tried to put this. [SysCom] Linux.Devicefile=/dev/ttyRS48 (remember, no 5 at the end!) then set com port in codesys to 6. It also works for me but want to know where did you get this. Thank you.
Can someone help me about my problem of my Modbus_Slave_Com_Port Not Running. I am using RevPiConnect 4 and I connected my actuator to the RS485 of my RevPI.
I want to know also if its advisable to use this Application trigger in Read Input Registers. I already try it with Write Multiple Registers.
Thank you Sir at first it was not functioning the Modbus Channel Im getting error but now its Okay. Do you know any project that I can try using this Application. Do you have sample program where in I have 2 Modbus Slave with Address 1 & 2. Using this Application trigger I wanted sample First Slave 1 equipment moves then Slave 2 and back again like a loop.
I just want to ask if someone knows how to use the Modbus RTU Slave using the Trigger type which is the Application.
Hello sir I have the same problem with codesys how do you manage to troubleshoot the problem. And what is that Syscom configuration are you saying. Hopefully you see my message. Im using Revolution Pi RevPi Connects.
Hello I have the same problem do you already fixed the issue
Hello I have the same problem do you already fixed the issue