Activity for Elad_Amira
-
Elad_Amira posted a comment on discussion Engineering 🇬🇧
Hi all, I want to start using EtherCAT_Master.xRestart function, insted of resetting the whole RTC. When I activate it and call the master again, the ethercat restarts, and all the devices are detected without errors, but all my softmotion axes are in error, that I can't release with reset/reinit. The axes are connected to different kind of drives so I guess the problem is with the Softmotion module. I am using an Advantech UNO-2484G controller Tried it with codesys version SP6 and with SP17. (3.5.6.3...
-
Hi, After too long, we are upgrading from Codesys SP6 to SP17 (3.5.6.3 -->3.5.17.1) and we encounter some problems with our existing project. We are using an Advantech UNO-2484G controller One of our ethercat devices is an ACS controller (Control 2 axes). When we use it with the default telegram settings it works fine. but, when adding additional data to the telegram - for expample reading the position error, we lose control over the axes (can't enable motor) after some investigation we found that...
-
Hi, After too long, we are upgrading from Codesys SP6 to SP17 and we encounter some problems with our existing project. We are using an Advantech UNO-2484G controller One of our ethercat devices is an ACS controller (Control 2 axes). When we use it with the default telegram settings it works fine. but, when adding additional data to the telegram - for expample reading the position error, we lose control over the axes (can't enable motor) after some investigation we found that after the change in...