Hi, I see the project but I have a previous version and I have some problem to open the project. I don't see problem... or wrong configuration... it will be helpful see the on-line behavior. Ciao Michele
Ok, post the project. I have Codesy 3.5.16.2 and 3.5.11 Ciao Michele
Hello Mirko, I can't understand what you want to do... But pay attention, TX signal is the signal received and not sended. Ciao Michele
Good morning, some question: 1. How you have configurated the J1939 manager? 2. Are you sure that you check the J1939 channel? 4 messages is not a lot. Ciao Michele
Hello, I'm new in codesys... and I have a big problem with the J1939. I use a CR1059 panel of IFM and I use a CAN Line to connect the PLC at the engine motor. I want to know the value of rpm and i punt in the TAB TX_signal the PGN 61444 (EEC1). But when I put the variable mapped on the program I don't read nothing. I use the pcan view and I read the traffic on the net CAN J1939. I see that the ECU send automatically some PGN and I can read this, but I can't read the value that I want to read. Can...