Hello, I am currently testing redundancy using two UC20-M4000 controllers with CODESYS Control SL. The basic redundancy functionality (Active/Passive switching and failover) works, but I am experiencing problems when updating the application. Environment Controller: Weidmüller UC20-M4000 OS: u-OS Runtime: CODESYS Control SL 4.12.1.0-1 Redundancy link: dedicated Ethernet connection between the two controllers Time synchronization: NTP configured, time difference between controllers is about 1–2 seconds...
Hi! thanks for reply. We tested the configuration you proposed as well; however, when the cable between the controller and the switch was disconnected, the Active and Standby roles were swapped. Did you observe the same behavior in your configuration using WAGO and Beckhoff?
Hello, I would like to ask whether it is technically supported (and practically achievable) to combine CODESYS Master Redundancy with EtherCAT ring (loop) redundancy in the same system. System setup CODESYS version: CODESYS 3.5.21.40 CODESYS Control SL for Weidmuller u-OS-4.12.2.0 Controllers (Masters): Weidmuller UC20-M4000 ×2, configured as Active / Standby using CODESYS redundancy EtherCAT Slaves: Weidmuller UR20-FBC-EC ×3, supporting EtherCAT ring / line break detection Topology: EtherCAT ring...