That clears a lot! Thanks. I used 192.168.0.51/24 in the enablebr0.sh. This to have a difference between the origin eth1 ip address and the /24 to have the same subnet (255.255.255.0). With /16 (255.255.0.0) I had issue on reaching 192.168.0.50. Guess due to missmatch in subnet settings. Anyway with this it now runs smooth! Two different device EoE parallel and EtherCat (48Byte PDO's to the two slaves) with 4ms.
That clears a lot! Thanks. I used 192.168.0.51/24 in the enablebr0.sh. This to have a difference between the origin eth1 ip address and the /24 to have the same subnet (255.255.255.0). With /16 (255.255.0.0) I had issue on reaching 192.168.0.50. Guess due to missmatch in subnet settings. Anyway with this it no runs smooth! Two different device EoE parallel and EtherCat (48Byte PDO's to the two slaves) with 4ms.
Hi, Got lost on this explanation on which IP and adapter goes where. In my setting the: - EoE device has the IP 192.168.10.10 -> this is what I put into the enablebr0.sh (192.168.10.10/24) - EtherCat runs on eth0 -> this is the adapter for enp1s0? - eth0 has a IP configured to be 192.168.10.1 - eth1 has a IP configured to be 192.168.0.50. This is where the PC is connected to the raspberry PI. - on my PC I have a route to 192.168.10.0 MASK 255.255.255.0 With this I'm able to ping 192.168.10.1. If...