Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I program a function for an Ethernet/IP controller. I made a structure with input and output corresponding with the map of my controller for the function block.
My problem is that I don't know how to do the link between the controller and my PLC (CC 100 from Wago). The addresses declare in Codesys are illogic, The first addresses are 12 and 13 then 7 then 4.
How to do corresponding the addresses of the controller and the input / output structure ? IP adress ?
Does I must create the all variables of controller with the controller adresses to use with the function block ?
Thanks for your help.
(I hope I'm clear, I'm not english)
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I program a function for an Ethernet/IP controller. I made a structure with input and output corresponding with the map of my controller for the function block.
My problem is that I don't know how to do the link between the controller and my PLC (CC 100 from Wago). The addresses declare in Codesys are illogic, The first addresses are 12 and 13 then 7 then 4.
How to do corresponding the addresses of the controller and the input / output structure ? IP adress ?
Does I must create the all variables of controller with the controller adresses to use with the function block ?
Thanks for your help.
(I hope I'm clear, I'm not english)