Hello everyone!
I'm new to the Codesys world and I was given a relatively easy task I don't get right.
I have to (continuously) read the value a sensor sends to my PLC as an analog signal.
I'm using:
- DELTA AX8 PLC
- DELTA R1_EC5500 (EtherCAT TO EBUS Adapter module)
- DELTA R1_EC8124 (Control Module)
- A sensor connected to the 8124
The 8124 Control Module has analog inputs that I can't really read in Codesys, even if the wiring is ok and everything seems working fine hardware-wise. Any advices on how to proceed?
Thank you everyone for your help!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everyone!
I'm new to the Codesys world and I was given a relatively easy task I don't get right.
I have to (continuously) read the value a sensor sends to my PLC as an analog signal.
I'm using:
- DELTA AX8 PLC
- DELTA R1_EC5500 (EtherCAT TO EBUS Adapter module)
- DELTA R1_EC8124 (Control Module)
- A sensor connected to the 8124
The 8124 Control Module has analog inputs that I can't really read in Codesys, even if the wiring is ok and everything seems working fine hardware-wise. Any advices on how to proceed?
Thank you everyone for your help!