I am coupling a Devicenet EL6752 Slave device with EtherCAT Coupler EK1100 through codesys v3.
I have made an Expert Process Data settings required size of input/output bytes as shown in image below.
The image below shows the startup parameters that I have configured so far.
The missing part so far is the mapping of the output/input data from/toward the master device with the input/output data on/from the slave device.
The problem is that I am not able to find a configuration settings for input/output connection polling data which can tell exactly at what index is the input data and at what index is the output data. So I am not able to exchange any data between the Devicenet master and slave devices. Can someone please suggest if I am doing it the correct way and is then how can I configure that data mapping between master and slave devices?
Thanks in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am coupling a Devicenet EL6752 Slave device with EtherCAT Coupler EK1100 through codesys v3.
I have made an Expert Process Data settings required size of input/output bytes as shown in image below.
The image below shows the startup parameters that I have configured so far.
The missing part so far is the mapping of the output/input data from/toward the master device with the input/output data on/from the slave device.
The problem is that I am not able to find a configuration settings for input/output connection polling data which can tell exactly at what index is the input data and at what index is the output data. So I am not able to exchange any data between the Devicenet master and slave devices. Can someone please suggest if I am doing it the correct way and is then how can I configure that data mapping between master and slave devices?
Thanks in advance.