I'm on a project to deal with some CANopen applications, using Automata's OptinJect as controller. Now I have two sets of libraries independent to each other: one set is from 3S, e.g. 3S_CANopenMaster.lib, 3S_CanDrv.lib, etc; the other set is from the PLC manufacturer, e.g. mcmlib.lib, mcmapplicationlib.lib etc.
These two sets are different systems, so I want to choose one of them to use. I heard that mcm.lib doesnot deal with eds files, so I want to choose libs from 3S.
My question is: Is the CANopen libs from 3S is powerful enough to deal with any application? or I should use the two set libs at the same time?
Thanks for caution!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi, everyone!
I'm on a project to deal with some CANopen applications, using Automata's OptinJect as controller. Now I have two sets of libraries independent to each other: one set is from 3S, e.g. 3S_CANopenMaster.lib, 3S_CanDrv.lib, etc; the other set is from the PLC manufacturer, e.g. mcmlib.lib, mcmapplicationlib.lib etc.
These two sets are different systems, so I want to choose one of them to use. I heard that mcm.lib doesnot deal with eds files, so I want to choose libs from 3S.
My question is: Is the CANopen libs from 3S is powerful enough to deal with any application? or I should use the two set libs at the same time?
Thanks for caution!
Well, no one replied.
I think 3S company's lib is enough, have a try.
have a look at w www.oscat.de w this is independent library.