I have a PD control block that i want to put in manual and open the output to a certain value. This must me done from a faceplate that was build. The switching between auto and manual on the faceplate works 100%. Do any one have any suggestions?
Regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good day.
I have a PD control block that i want to put in manual and open the output to a certain value. This must me done from a faceplate that was build. The switching between auto and manual on the faceplate works 100%. Do any one have any suggestions?
Regards
use SEL for example to switch between both outputs, or you could have a look at oscat.de for several PID controllers.