Okay, I have a question, I am using V2.3, with ifm cr0232. I have an analog input from a pressure sensor 4-20ma. I am trying to use input_analog function block but I am not getting an output. I dont understand what Mode should be and what Channel this should be on. I am unable to put the analog input channel in the Channel field because it requires a byte and not a word input. I have tried, 07, 7, analog07, ect with no success.
Any thoughts.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Okay, I have a question, I am using V2.3, with ifm cr0232. I have an analog input from a pressure sensor 4-20ma. I am trying to use input_analog function block but I am not getting an output. I dont understand what Mode should be and what Channel this should be on. I am unable to put the analog input channel in the Channel field because it requires a byte and not a word input. I have tried, 07, 7, analog07, ect with no success.
Any thoughts.
My question was solved on the IFM Forum. Thank you. I had to use the block input_analog_E instead of input_analog.
What IFM forum?