Hey all, I am trying connect raspberry pi with instaled codesys to s7-1200 via Profinet. I can't get connected behind devices, despide of I see raspbbery pi in tia portal when I scanning network. The raspberry was configured as same as on page: https://content.helpme-codesys.com/en/CODESYS%20PROFINET/_pnio_runtime_configuration_device.html
The PLC is master, so in codesys is defined profinet device. Also I generated GSD file from codesys and imported to TIA portal.
After connection with device codesys send error: ,,IP-Change not enabled on specified interface! Enable update of IP-address in *.cfg -file" ant i have two red triangles by CODESYS_profinet_device and definition of IO.
Is it any solution? Could you help me? May I should acrivate profinet?
If all it ok, could you please check this points: Re generate GSDXML file from Raspberry The station name is the same in you Codesys project and TIA project.
* And the the inputs outputs of the Profinet configuration
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hey all, I am trying connect raspberry pi with instaled codesys to s7-1200 via Profinet. I can't get connected behind devices, despide of I see raspbbery pi in tia portal when I scanning network. The raspberry was configured as same as on page: https://content.helpme-codesys.com/en/CODESYS%20PROFINET/_pnio_runtime_configuration_device.html
The PLC is master, so in codesys is defined profinet device. Also I generated GSD file from codesys and imported to TIA portal.
After connection with device codesys send error: ,,IP-Change not enabled on specified interface! Enable update of IP-address in *.cfg -file" ant i have two red triangles by CODESYS_profinet_device and definition of IO.
Is it any solution? Could you help me? May I should acrivate profinet?
Hi ane-ste,
I make this connection a few months ago. I followed this link and it worked. https://forge.codesys.com/forge/talk/Runtime/thread/0befdf48e8/
If all it ok, could you please check this points:
Re generate GSDXML file from Raspberry
The station name is the same in you Codesys project and TIA project.
* And the the inputs outputs of the Profinet configuration