Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a project with two CANbuses. I have measured the bus load of each bus using PCAN Explorer. Bus load is ~55% for one bus and ~40% for the other. Sadly, the CANbus Status tab for each bus always shows 16%, which is obviously wrong. How can I get the correct bus load?
The PLC is a CrossControl CCpilot XM2.
Device Information:
Name: CODESYS Control, x86 From CrossControl
Vendor: CrossControl AB
Categories: PLCs
Type: 4096
ID: 162a 0001
Version: 3.5.9.30
Order number: ???
Description: CODESYS Control from CrossControl
I have a project with two CANbuses. I have measured the bus load of each bus using PCAN Explorer. Bus load is ~55% for one bus and ~40% for the other. Sadly, the CANbus Status tab for each bus always shows 16%, which is obviously wrong. How can I get the correct bus load?
The PLC is a CrossControl CCpilot XM2.
Device Information:
Name: CODESYS Control, x86 From CrossControl
Vendor: CrossControl AB
Categories: PLCs
Type: 4096
ID: 162a 0001
Version: 3.5.9.30
Order number: ???
Description: CODESYS Control from CrossControl
Last edit: andyfox 2020-11-12