I have a WAGO PLC, to which I am establishing a connection. Here I use the autodiscover to register the connected modules. Now, I have tested the in-/outputs of the different modules, to verify they are consistent with how they are physically connected to the PLC in regards to how CODESYS has numbered them.
Will CODESYS always number the modules closest to the PLC itself lowest, and the one furthest away, the highest?
I am rather new to the program, so I both hope my question makes sense, as well as not being completely obvious. Thanks!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a WAGO PLC, to which I am establishing a connection. Here I use the autodiscover to register the connected modules. Now, I have tested the in-/outputs of the different modules, to verify they are consistent with how they are physically connected to the PLC in regards to how CODESYS has numbered them.
Will CODESYS always number the modules closest to the PLC itself lowest, and the one furthest away, the highest?
I am rather new to the program, so I both hope my question makes sense, as well as not being completely obvious. Thanks!
I would say that I kind of got an explanation though this document on the WAGO PLC.
https://techdocs.wago.com/io-system/750_753/system/en-US/index.html#92248203