Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I try to read a smart meter with a Windows CE controller. Bought a USB cable. Copy the drivers to the ordner Windows. But after power off the drivers are gone. Knows anyone how to do that? I want the usb as a vurtial com port
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
You need to be able to enable the "write" functionality to change the OS. Windows CE is loaded on startup with the default configuration. So you can write to it, but when restarting, it loads the default again. This is done for security and stability reasons. Pleae check with your vendor how to enable changing this.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I try to read a smart meter with a Windows CE controller. Bought a USB cable. Copy the drivers to the ordner Windows. But after power off the drivers are gone. Knows anyone how to do that? I want the usb as a vurtial com port
You need to be able to enable the "write" functionality to change the OS. Windows CE is loaded on startup with the default configuration. So you can write to it, but when restarting, it loads the default again. This is done for security and stability reasons. Pleae check with your vendor how to enable changing this.