CODESYS Forge - CODESYS Forge / Talk / Engineering 🇬🇧: Error IoDrvEthernetIP: Connection Failure. (16#1) How to solve

Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Error IoDrvEthernetIP: Connection Failure. (16#1) How to solve

Forum: Engineering 🇬🇧

Creator: gabriellopes

Created: 2022-06-01

Updated: 2024-03-07

gabriellopes - 2022-06-01

Hello everyone,

I am facing an issue regarding Codesys. I am working in a project where I connect a raspberry pi with a Wago Remote IO 750-352 using the "CodeSys Control for Pi SL". I could configure all the other devices but when it comes to the remote itself I get an error that I cannot find the source.

Does anyone has any idea how to solve this?

print1.PNG

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

i-campbell - 2022-06-01

press the + next to the error message, and you get a slightly more specific error message.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

gabriellopes - 2022-06-01

Thank you for the reply.

That is the more specific error message.

print2.PNG

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

i-campbell - 2022-06-02

The size will have to match. Maybe the 750-352 can be accessed from a webbrowser, that it may tell you the correct sizes to use.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

gabriellopes - 2022-06-02

Sorry for the question, but could you tell me what are those sizes and what they mean.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

i-campbell - 2022-06-02

In the PLC, the sizes are on the connection tab of the remote adapter.

https://content.helpme-codesys.com/en/CODESYS%20EtherNetIP/_enic_edt_target_connections.html

I am not sure about how you get the sizes from the Wago. It is either on the web interface, or you will have to find the manual for it.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- harinator - 2022-06-15
  
  Hello,
  
  I'm getting a similar error Error IoDrvEthernetIP: Connection Failure. (16#1) when connecting to a Ethernet IP Driver (Oriental Motors AZD-AEP driver). But when expanding the error, I'm getting reasons like "Connection timeout" or "Ownership conflict"
  
  Is this related to size as well?
  
  Connection error AZD AEP.png
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

SumNature - 2024-03-07

harinator,

I am facing the the issue. Were you able to find the solution.

thanks,

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.