Hello,
I am using X-Soft CODESYS on an EATON-Panel at the customer. It is connected via a Secomea-Modem for remote access. 4 Month ago, there was a connection and I was able to upload the software.
But now I can not access the PLC anymore. The device is not responding.
The Settings of the Secomea Modem are still the same:
When I try to ping the device, there is a reply.
I also watched it in Wireshark: first the ping and then I tried to connect in the CODESYS IDE
So some Questions:
1. Am I doing something wrong in general?
2. Why is the Ping working but not the CODESYS connection?
3. How can I establish a workinmg connection?
4. I often read about Gateway on a raspberrypi. Do i need a Gateway? I think with the Secomea Modem, the connection should be possible as it was directly pluged to the PC
Thank you in advance!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am using X-Soft CODESYS on an EATON-Panel at the customer. It is connected via a Secomea-Modem for remote access. 4 Month ago, there was a connection and I was able to upload the software.
But now I can not access the PLC anymore. The device is not responding.
The Settings of the Secomea Modem are still the same:
When I try to ping the device, there is a reply.
I also watched it in Wireshark: first the ping and then I tried to connect in the CODESYS IDE
So some Questions:
1. Am I doing something wrong in general?
2. Why is the Ping working but not the CODESYS connection?
3. How can I establish a workinmg connection?
4. I often read about Gateway on a raspberrypi. Do i need a Gateway? I think with the Secomea Modem, the connection should be possible as it was directly pluged to the PC
Thank you in advance!
I Don't know your Gateway, but isn't it a routing device ?