In the CFC page oriendted editor, if I copy some elements consisting of an input connector, some connected logic and an output connector and then paste this on a another page then the pasted elements get inserted with an offset to the right so that the rightmost connector falls outside of the page, in the grey hatched area. So far so good. Then I mark all the elements and try to drag them into the correct placement, collectively. THIS IS NOT POSSIBLE! I only get the "forbidden" icon tooltip. One has to drag & drop the INDIVIDUAL elements to move the elements around.
What am I doing wrong?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
In the CFC page oriendted editor, if I copy some elements consisting of an input connector, some connected logic and an output connector and then paste this on a another page then the pasted elements get inserted with an offset to the right so that the rightmost connector falls outside of the page, in the grey hatched area. So far so good. Then I mark all the elements and try to drag them into the correct placement, collectively. THIS IS NOT POSSIBLE! I only get the "forbidden" icon tooltip. One has to drag & drop the INDIVIDUAL elements to move the elements around.
What am I doing wrong?