Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm new to codesys, and I don't see a way to receive a DM1 message via the J1939 Manager / J1939_ECU. I can broadcast a DM1, but what if I want to read the DM1 from say the engine and act on it? The P2P RX Signals doesn't allow me to add it as a custom parameter group either.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm new to codesys, and I don't see a way to receive a DM1 message via the J1939 Manager / J1939_ECU. I can broadcast a DM1, but what if I want to read the DM1 from say the engine and act on it? The P2P RX Signals doesn't allow me to add it as a custom parameter group either.