Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i am trying to create a program using codesys control win as the plc and ifm cr2012 i/o modules as the outside interface.
the data is trasmitted via canopen, i am using the provided eds files for the configuration of the i/o modules.
i am having no problem receiving binary inputs but dont seem to be receiving any values for the analogue inputs. i can see on my pcan software that the data is being transmitted but it isnt appearing on the mapped variables in the device?
any ideas why would be greatly appreciated. thankyou
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hi all,
i am trying to create a program using codesys control win as the plc and ifm cr2012 i/o modules as the outside interface.
the data is trasmitted via canopen, i am using the provided eds files for the configuration of the i/o modules.
i am having no problem receiving binary inputs but dont seem to be receiving any values for the analogue inputs. i can see on my pcan software that the data is being transmitted but it isnt appearing on the mapped variables in the device?
any ideas why would be greatly appreciated. thankyou