I’m using CODESYS EtherCAT Master on a Raspberry Pi controller with several remote I/O modules.
I’m facing an issue where the input values from the remote I/Os drop to 0 when a connection error occurs.
Is there a way to configure a “keep last value” behavior (i.e., hold the last valid input) instead of defaulting to 0 on communication loss?
Best regards,
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I’m using CODESYS EtherCAT Master on a Raspberry Pi controller with several remote I/O modules.
I’m facing an issue where the input values from the remote I/Os drop to 0 when a connection error occurs.
Is there a way to configure a “keep last value” behavior (i.e., hold the last valid input) instead of defaulting to 0 on communication loss?
Best regards,