Hi,
I'm trying to communicate with a MoviconCE HMI to a codesys PLC.
During Movicon Codesys driver configuration I can check the communication with the PLC and it seems Ok, I can also import the variable, reading it from the PLC (the edge gateway is correctly running on it), but when I run the Movicon Project into the HMI, I get "communication error 87" and my variable remains to "0".
Using a x86 PC (my developing PC) and the same Movicon project I can read the variable correctly.
So it seems that the CE HMI has not all the requisites needed but I cannot get any information about this.
Somebody can help me?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I'm trying to communicate with a MoviconCE HMI to a codesys PLC.
During Movicon Codesys driver configuration I can check the communication with the PLC and it seems Ok, I can also import the variable, reading it from the PLC (the edge gateway is correctly running on it), but when I run the Movicon Project into the HMI, I get "communication error 87" and my variable remains to "0".
Using a x86 PC (my developing PC) and the same Movicon project I can read the variable correctly.
So it seems that the CE HMI has not all the requisites needed but I cannot get any information about this.
Somebody can help me?