Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have set up the sender and reciever for network variables on two PLCs.
And everything works perfect.
However, I have noticed that PLCs can't exchange the data in some of the new downloads.
E.g. the first download of application to PLCs is fine, second time is also fine and then the third time, no. I have to do a power cycle on both PLCs, then it is working again.
Best regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi
I have set up the sender and reciever for network variables on two PLCs.
And everything works perfect.
However, I have noticed that PLCs can't exchange the data in some of the new downloads.
E.g. the first download of application to PLCs is fine, second time is also fine and then the third time, no. I have to do a power cycle on both PLCs, then it is working again.
Best regards